The initial state of each layer in the thermal insulation and decoration integration is good, especially the ideal situation of the thermal insulation layer is to make its six sides rigidly connected. The selection of raw materials should make the elastic modulus and hot (cold) thermal expansion coefficients continuous or far apart as much as possible. When installing at the construction site, a 1-2MM wide joint is reserved between the two boards. After the mortar at the bottom of the finished board is completely dry, the joint is filled with weather-resistant sealant. It is necessary to analyze the thermal and thermal changes of the thermal insulation and decoration integrated board according to the actual situation.

Thermal insulation and decoration integration

In addition, the construction steps and operation methods of thermal insulation and decoration integration can show that the entire construction process is relatively simple, which can effectively shorten the construction period and save construction costs. This is also its characteristic relative to other wall materials. At the same time, when making the external wall thermal insulation and decoration integrated board, the lack of technology will also affect the quality of the external wall thermal insulation and decoration integrated board. Such boards are prone to falling off during use.

In addition, after the thermal insulation and decoration integration begins, the construction line in the vertical and horizontal directions should be used as the starting point of the construction, and the graphics of the four walls should maintain the standard line and have the same correlation. The quality of the anchoring work of the thermal insulation integrated board will directly affect the service life and thermal insulation effect of the board. Therefore, if the board is anchored according to the above method, it will extend the service life of the board, improve the thermal insulation effect, and can be used for the thermal insulation and decoration of the exterior walls of new buildings.

Overview: Thermal insulation and decoration integration is an insulation and decoration system placed on the surface of the building wall. The thermal insulation effect is long-lasting, the thermal bridge effect is small, and the energy-saving and thermal insulation effect is good. The exterior wall insulation system can withstand the cold and hot changes of the external natural environment for a long time. In the south, there is a lot of rain, and it is often accompanied by rain. You can choose more decorative layers with waterproof and anti-corrosion effects. In the north, you need to choose thermal insulation and decorative integrated boards with anti-freezing and anti-falling effects.