The integrated exterior wall insulation decoration is connected to the structural wall by bonding force and mechanical anchoring force. The weakest part is the connection between the mortar and the polystyrene board. Its compressive shear bonding force is used to overcome gravity, and the tensile bonding force is used to resist the tension caused by wind pressure and gravity bending moment. The existence of fiberglass mesh prevents the external insulation system from forming a whole well. The coating layer on the surface of fiberglass weakens the tensile strength of the plastering mortar. The pull-out strength of the steel wire mesh is greater than 0.4MPa, which can meet the standard requirements.

If the surface layer of the integrated exterior wall insulation decoration is paint, the bonding area of the bonding mortar can be increased by empirical calculation. If the exterior wall decoration is tiled, from a safety perspective, it is strongly recommended to use paint imitation bricks instead of tiled tiles. The insulation system is mainly pasted, supplemented by anchoring, and dust on the base. In the decoration of new buildings and the renovation of old buildings, insulation materials can well overcome problems such as mold, peeling, and cracking of the wall, and effectively overcome the problem of warping or deformation of the outer corners after the board is spliced.

Excellent insulation and decoration effect (thermal conductivity 0.023w/(m*k). The insulation and decoration integrated board is formed into insulation materials and decoration materials in one step in the factory. The insulation material is a new type of insulation material with various finishes, and one-time construction can achieve excellent insulation and decoration effects.

Configuration of integrated insulation and decoration materials for exterior walls (the following description takes WW insulation materials as an example) According to different regions, different seasons, different climate characteristics, different air humidity, and different base wall materials, the weight ratio of WW inorganic insulation materials to water is about 1.5:1, and stir for 3-5 minutes.