When used in the integrated insulation of exterior wall insulation and decoration, there are often quality problems such as system shedding and surface cracking. Due to its high cost, this material is not as advantageous as expanded polystyrene board in the field of exterior insulation.

It is also suitable for energy saving and decoration renovation of old buildings, and is suitable for all kinds of public buildings as well as for exterior wall insulation of residential buildings. It is suitable for construction in cold areas in the north and in hot areas in the south. Since the slight unevenness and roughness of the base wall can be adjusted by special mortar, the flatness and finish of the insulation and decoration integrated board on the base are relatively low, and the treatment is relatively simple.

When installing the integrated exterior wall insulation and decoration on site, a 5mm-10mm wide joint is reserved between the two boards. When the mortar at the bottom of the finished board is dry, fill the joint with foam material, and then fill the entire joint with weather-resistant sealant.

The integrated insulation and decoration of exterior wall insulation and decoration strives to meet the basic requirements. The room temperature of urban buildings in summer is lower than 30℃, and the temperature in the heating area in winter reaches 18℃. It is not only suitable for newly built brick-concrete structure, frame structure, steel structure, lightweight house and other types of buildings, but also suitable for decorative energy-saving transformation and outdoor decoration of existing buildings. As the old house is renovated, the quality of the house can be changed.

The integrated exterior wall insulation decoration should be placed on a dry, solid, flat ground and away from the mechanical workplace. The boards should not be placed upright and scattered, and should be neatly stacked according to different specifications and types. For some new exterior wall insulation materials, the technology cannot be completely denied simply because the factory quality is not good. The resonance coefficient of the insulation material with completely closed holes should not be considered low from the technical level, but it should be judged as a high-quality material.