The integrated panel system of exterior wall insulation decoration is equal to integrated exterior wall decoration. It reduces the communication cost and time cost brought by multiple units in procurement and on-site management, reduces the construction steps, shortens the construction period, and the thickness of the later construction should be less than that of the last construction. It is advisable to leave a thickness of about 10 mm at a time.

The factory of the exterior wall insulation layer hangs a vertical line with a line, and a standard sticker is affixed at about 10 cm from the bottom of the floor and 10 cm from the large wall sound/yang corner. (When the floor is high, two people are required to complete it together) After that, the standard stickers are affixed vertically at intervals of 1.5 meters. That's why I replaced them with thin insulation boards. Check the flatness and verticality of the surface of the base layer to ensure that the requirements of the intermediate mortar are met.

Improve the selection of exterior wall insulation materials from the customer's perspective: Mix with cement mortar and rubber powder to form insulation particles. In the technical engineering field of wall insulation materials, inorganic polymer boards are surrounded by a hard calcium carbonate film wrapped with PVC resin. Then it deviates from the purpose of installing the material, so when installing, it should be strictly constructed in accordance with the construction standards.

The installation sequence of the integrated exterior wall insulation decoration board is as follows: basic inspection, emptying of the grass wall, peeling and leveling, tape pasting, silicone weatherproof sealant injection, special breathable plug installation, cover paper removal, panel cleaning, etc. The exterior wall insulation material factory will apply the prepared special adhesive on the back of the extruded board, and the compacted thickness of the adhesive is about 3. In order to ensure firm bonding, the bonding method can be divided into strip bonding method and strip point bonding method.

The exterior wall insulation decoration integrated board project will first clean the concrete wall dust to see if there are any dirt such as demolding agent oil stains. If there are hollow positions on the putty wall, they should be repaired. Seal the various holes tightly.